Industry background

Industries & Applications

Pulp and paper

Pulp and paper mills run some of the hardest-working motors in industry. Monitoring their true power shows how evenly wood and pulp are being fed, protects chippers and refiners from crashes and tramp metal, and reveals knife and plate wear from the power trend.

Chippers

Chipper load follows wood density, moisture and feed rate, and it rises as the knives dull because more power is needed to cut the same volume. Tracking power for a standard feed tells you when knives need changing, based on their actual condition rather than the calendar. A fast rate-of-change control trips the motor on a crash or tramp metal strike within milliseconds, before the knives or drive are destroyed.

Refiners

Refiners are among a mill's largest energy users, and fibre quality depends on the energy applied to each tonne of pulp. Motor power is the basis of that specific-energy calculation and of feed control that keeps refiner load steady. A sudden spike signals tramp metal or plate contact; plate replacements can cost tens of thousands of euros.

Feed screws, conveyors and barkers

  • Plugging and bridging: when a feed screw bridges, load drops immediately. An underload alarm can trigger the screw to reverse and clear the blockage.
  • Slugs and overfeeding: sudden increases are caught by a warning set point before the trip level is reached.
  • Constant workload: the power signal can adjust conveyor or screw speed so the downstream machine sees a steady load.
  • Barkers and de-knotters: overloads from large logs or clogging by rejects show up in motor power.

Stock pumps and agitators

Stock pumps lose flow when consistency changes or a line plugs, and chest agitators can lose a blade or overload as consistency rises. Power sensors with low and high trip points protect both. See monitoring and protecting pumps.

Energy and maintenance data

Logged in kWh, motor power gives cost per tonne for each stage of the process and supports an ISO 50001 energy baseline. See energy efficiency and ISO 50001.

Recommended products

Further reading: Electronic shear pins, Conveyors: jam detection, Why measure power, not amps

Frequently asked questions

Can motor power tell me when chipper knives need changing?

Yes. Dull knives need more power to cut the same volume of wood. Comparing power for a standard feed over time shows the wear, so knives can be changed on condition.

How quickly can a control react to tramp metal?

The ROC-50 trips on the rate of load rise and responds in 25 milliseconds, which is fast enough to stop the motor before most of the shock reaches the knives, plates or drive.

Which sensor do I need for a large refiner motor?

The PH-1000 covers motors up to about 750 kW. For larger motors, tell us the rating and the existing current transformers and we will advise.

Can the signal control feed rate?

Yes. The analogue output can be used by your DCS or PLC to adjust screw or conveyor speed and hold the load on the downstream machine constant.

Industry application image

Key applications

  • Chipper protection and knife wear
  • Refiner load and specific energy
  • Feed screw and conveyor plugging
  • Tramp metal and crash detection
  • Stock pump and agitator monitoring
  • Barker and de-knotter overload

White Paper: Using Power Sensing to Monitor and Protect Pumps

How motor power sensing protects stock pumps and improves reliability.

View resource →

Application Note: Electronic Shear Pin Controls

Protecting agitators, refiners and chippers from overloads, jams and obstructions.

View resource →

Need the right sensor for your motor?

Tell us the application, motor size and drive type. We will recommend a model and send you a quotation. 12-month warranty and support from our team in France.

Request a quoteBrowse products